#1
|
|||
|
|||
Intermittent failure to start
So finally got the 85 740TD running for my kid, but what has happened this week is a synopsis for how it works (or doesn't). Lo/hi temps are 75/100, so no cold start issues.
1. Sunday, Monday, Tuesday - 2 good, quick starts 2. Wednesday 3 rough starts (longer cranking), then won't start at all, just cranks One started it runs fine. Since this is not a new problem, I have checked/done the following: 1. Glow plugs good, getting voltage 2. Fuel solenoid working, getting voltage 3. New filter and filter o-rings appear sealed 4. Cleaned injectors 5. Checked for air in the fuel lines, by placing clear tubing from A. tank - filter and B. filter-pump inlet (tubing in place now). No bubbles in either, BUT now that car won't start, there is no fuel in the tube. Priming by manually dumping fuel in sometimes works. The injector pump was new, but it sat for 4-5 years before I bought it. I suspect that the shaft seal may be slowly pulling air in, until it air locks and won't move fuel anymore. But how can I confirm this? The pump screams 'do not disturb' with the glyptal and the lock wire, and I have no experience with these, so I am hesitant to tear into it. Where do I go from here? I have put so much time into this car, and really like it, but I am ready to sell, because I can't have it stranding my daughter all the time. Thanks. Bill in AZ |
#2
|
|||
|
|||
Sounds to me like it's pulling air into the injection pump. I would replace the 1/4" fuel supply lines from IP to filter and from Filter to car. I would also make sure all the banjo fittings are sealed with new crush washers. Also make sure fuel filter is sealed.
You can add a small inline electric pump pre-filter to pump the fuel if you think the injection pump shaft is pulling air. Check the tension on the injection pump belt, if it's not fairly slack then most likely you will have a bad input shaft bushing/seal.
__________________
12mm pump heads, ARP stud kits and GTD nozzles available! http://d24t.com/showthread.php?t=1646 NA intake manifolds and 240 turbo pans for sale. Need d24 or d24t parts? PM me! Shipments done on fridays! 1982 242 D24+T/M46- Super pumped! Build thread: http://www.d24t.com/showthread.php?t=1545 1984 764 D24T/ZF build thread: http://www.d24t.com/showthread.php?t=1734 Diesel parts cars: 82 244,83 244, 84 244, 84 245, 85 745 |
Thread Tools | |
Display Modes | |
|
|