|
|
#1
12-10-2009, 08:03 AM
|
|||
|
|||
Bleeding Fuel Injector lines
I have D24T and need help bleeding the injector lines, I have fuel at the filter but none coming out the injector lines. I have a vacuum pump for bleeding brakes but I do not know where to put the vacuum, on the end of each line then turn it over? Any help is much appreciated
|
|
#2
12-10-2009, 09:04 AM
|
||||
|
||||
|
No vacume needed. Just crack the lines open at the injectors and crank it over. Hold the accelerator to the floor so the pump is pushing the most fuel possible, it will bleed out much faster. If the pump is dry you need to fill it with diesel or it will never prime. Take off the return line banjo at the top of the pump and fill it with fuel with a small funnel untill it runs out of the hole.
Jason
__________________
  Back again with a '84 760 GLE D24T/ZF SOLD but not forgotten! 1984 760 Sedan, built D24Tic/ T-5 swapped My engine build: http://www.d24t.com/showthread.php?t...t=engine+build T-5 swap: http://d24t.com/showthread.php?399-W...to-quot-w-pics!
|
 |
|
|
Linear Mode
