Thanks for the reply. Yeah it was just the two diameters thanks. Yeah I knew about the thickness relating to the pressure. I was hoping to order a bunch of each shim if they aren't too expensive. I may need to take apart the spare injectors and see what shims are in there first then. I'm aiming for 165bar of opening pressure and I think stock is 155? I don't suppose there are any rules of thumb when it comes to thickness and pressure? Also I read somewhere that you can stack shims, Is that correct?
Thanks again
Tristan
Last edited by BogfordGarage; 09-07-2022 at 10:44 PM.
|