If I had a sandblaster...wow... Long day here with the d24T
There was some or little progress because the manifolds were soaking in diesel then I had to manually clear up the intake from the oil that was inside. It took a lot of work... the lung cancer is fixed now. I used a strong but flexible handle toothbrush attached to a stick and tried to reach in everywhere through the 8 holes available.
The plan is to machine sand it down later to create a surface that looks nicer and would be much easier to keep clean once the engine gets in a car. The factory could have done a much better job at finishing surfaces on these.
Even inside the cylinder head they left huge mold-chunks and weird edges all over the tunnels. Crazy.
The engine needs to dry before manifolds and gaskets can get back up again...at least I win some time to deal with checking and cleaning the turbo, the oil cooler, intake piping and etc.
I'll I think take off the EGR mushroom and seal the exhaust manifold. I'm just afraid of those 2 studs bc I always managed to either strip the threads or brake them off. Maybe I should leave them alone and deal with it later. Intake dated 02.27.1985.
Last edited by RedArrow; 07-10-2020 at 09:09 PM.
|