Thread: Pilot bushing
View Single Post
  #3  
Old 04-28-2024, 09:52 AM
Enterprise Enterprise is offline
Junior Member
 
Join Date: Mar 2024
Location: Finland
Vehicle: 940 D24TIC
Posts: 11
Default

Quote:
Originally Posted by v8volvo View Post
You have tried with a blind hole puller? They make specially for pilot bearings. I would be afraid to cut it for fear of damaging the crankshaft, but if you are careful I would guess you could succeed that way. Some people also have good luck packing the recess with grease and then carefully using a correct sized dowel to pound in and then make the grease force the bearing out, basically a hydraulic method.

Is there a pilot bushing for the ZF torque converter? I always thought they just slip in there and are correctly sized to the back of the crank. If there is a bushing, then you definitely do need it -- running without it could cause the torque converter to move with eccentric motion and that would destroy the front seal on the trans, or worse. I'll look at that engine in my shed again but I'm surprised if there is a bushing.

I would make the main goal getting the M90 pilot bearing out first and then measure the crank recess bore diameter. Compare to the pilot stub on the ZF torque converter. Hopefully they are the same and it'll slip right together.

If not, and if there really is a pilot bushing, I'm happy to pull one out of an automatic motor and ship to you. I imagine it wouldn't be expensive to ship internationally, as small as it is.
Well.... i got it out but i had to cut with a dremel and i cut a small groove into the crank. I hope it wont be a big deal....
I am NOT replacing the crank so ill just ignore i.
The inside of the crank measures at 28mm flat and the pilot on the torque converter measures at 24mm flat so yes, there should be a bushing for the trans. The bushing should be 22mm flat deep also.
Now to fabricate one, how much play should the inner hole have? I was told 0,5-0,9mm so that would leave it at 24,5-24,9mm inner hole diameter. Sound right? I dont know.

Im unsure if you ship one to me since mine was so fckn tight in the crann you WILL damage it enough when removing it to render it useless. If not i will gladly pay you whatever it costs. But right now i think fabricating one sound like a better idea. It cant be THAT precise can it? Haha

The torque converter move even with the bushing in place as it is designed with the three fastening brackets being able to move on tq. So some play there should be. I guess it centeres itself when it moves?
Reply With Quote