Installing monark nozzles.
Hello,
I am rebuilding my D24Tic completely, so I am also swapping nozzles as the old ones was very bad. I got myself a set of new Monark 39 305 138 that I found here on the Forum, and I am going to set the pop pressure to 2400psi, but I don't know where to get the shims needed.. Can someone help me out? :) Also, as the pop pressure are set higher, the timing of the pump should probably be a little different? What timing is preferred with the new nozzles? :) Best regards -E.Winjum |
|
Thanks alot! :)
|
injector refurb,clean,adjust
great info. thank you.
|
All times are GMT -8. The time now is 04:52 PM. |
Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.