tight leak off pipes
hi all i recently purchased a length of leak off pipe from Brickworks uk , the bore diameter is 3.2 mm which i believe to be correct for the D24 engine injectors
the the pipe is a very good quality but , a little tight on the edge that runs onto the injector i have tried and tried , question !. is it safe to try and force the leak off pipes over a couple of degrees with utmost care ? , to allow the pipe to sit snugly down at the bottom of the leak off pipe , i have replaced these pipe numerous time over the years with a budget range ,so i thought i woud get better quality i also purchased a genuine VW stop end whichich does fit snugly over the leak off pipe it is a thinner gauge too regards jim |
Oftentimes you can make the rubber temporarily more compliant by heating it up immediately before fitting it. I use a heat gun.
|
940 tic auto 1995
THANKS FOR THAT ADVICE NGOMA .very good idea i will try this and let you know how i get on
regards jim |
All times are GMT -8. The time now is 05:46 PM. |
Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.