Well I finally looked under the hood today. Just to confirm dimensions, I measured 26 1/2" from the bellhousing bolt-up surface to the extreme front of crankshaft pulley. It should be mentioned that to that dimension you should add the radiator fan and clutch. Also, the injector belt drive and cover project back over the top of the bell housing ~ 2 1/2 inches. You will need some space between the firewall and the belt drive also as other wise you will have to remove the engine or something extreme, just to set the pump timing.....
Steve
|
05-04-2012, 08:33 PM
Hybrid Mode
