Unplanned Head Job (I made the mistake so you don't have too!) Part 1.

[ngoma]

Female spade connector on the brown wire that runs to the GP relay connects to the temperature sensor at the rear of the head. It slides onto the round disc standing off the end of the sensor, just slides on perpendicularly. It provides input to the GP relay logic, to determine whether to energize the GPs at start or not.

The other water temp. sensor, near the front of the head by #1 GP is for the instrument panel temp. gauge.

Attached photos of the rear bussbar. The bends allow it to thread thru the IP mounting bracket. The #6 GP connection is slotted open to ease removal/install. The small nut on the GP terminal just needs to be loosened, not entirely removed (and lost!).

http://d24t.com/attachment.php?attac...1&d=1508869984

http://d24t.com/attachment.php?attac...1&d=1508870006