Quote:
Originally Posted by genegr
Will I need to get a longer belt?
|
No, the IP rotates on its axis. You might want to replace the belt as a maintenance item as long as you are going to remove the IP, as you say.
Quote:
Originally Posted by genegr
Guess I don't see yet how it can move away from the head anymore than it is.
|
It rotates on its axis; the top can swivel away from the head a few inches, allowing for easier access to the injectors. Rotating (and reclamping) the IP away from the head will significantly retard the timing, that's why you need to retime it after repositioning.
Quote:
Originally Posted by genegr
I'm going to remove this pump anyways and have it rebuilt. I just want to try or check the timing before I move anything.
|
Not a bad idea, always good to set a benchmark so you know what you started with. For R/R the IP I like to take it out still attached to the cast iron IP bracket. When reinstalling just have to make sure the belt is not too tight. Too tight will overstress the IP shaft bushing, leading to leaks, loss of prime, hard starting, poor performance, etc.